|
|
Easy-Fence Products are easy to install: Only 10 minutes to set up. No Welding, drilling or maintenance!
|
|
|
|
|
|
|
Fence Panel Installation |
Five Easy Steps |
Print out the PDF Instructions Here |
Step 1:
Drive Post #1. Post should be 7 feet in length or longer.
Clamp Large Panel to the post as shown.
|
|
Step 2:
Move the panel slightly out of line. Drive post #2, as shown, in order for the post hole driver to clear the brace panel.
Note: Be sure the post is tight against the brace panel.
|
|
Step 3:
After driving post #2, hold it tightly against the top of the Large Panel. At the same time, secure both theLarge and Small Brace Panels at the top of the post with a clamp. Attach a second clamp at the bottom of the panels and T post.
Note: If rocky soil prevents post from fitting tightly against brace panel, bend the T post to the brace panel to fit tight.
|
 |
Step 4:
Drive post #3 and secure Small Brace Panel to it as shown.
|
|
Step 5:
On slopes or grades adjust the brace up or down as needed. For sandy soils or swamps a "dead man" post may be used to provide extra support. A T post is triven into the ground next to the original T post and panel until only the top is above ground. This "dead man" post is then clamped to the original post and panel.
|
 |
|
|
|
